Streamlight Stinger LED HL 120/DC PB

Streamlight Stinger LED HL 120/DC PB Flashlight

Naudotojo instrukcija

1. Įvadas

This manual provides detailed instructions for the safe and effective use of your Streamlight Stinger LED HL 120/DC PB rechargeable flashlight. Please read all instructions carefully before operating the device.

Saugos informacija

  • Do not look directly into the LED light. The intense beam can cause temporary vision impairment.
  • Laikyti vaikams nepasiekiamoje vietoje.
  • Use only Streamlight approved batteries and charging equipment.
  • Do not attempt to disassemble the flashlight head or battery pack.
  • Saugokite žibintuvėlį nuo ekstremalių temperatūrų ar korozinių skysčių.
Streamlight Stinger LED HL 120/DC PB Flashlight

Figure 1: Streamlight Stinger LED HL 120/DC PB Flashlight. This image shows the blue tactical flashlight with its distinct head and body design.

2. Sąranka

2.1 Pradinis akumuliatoriaus įkrovimas

Your Streamlight Stinger LED HL 120/DC PB flashlight comes with a rechargeable NiMH battery. Before first use, fully charge the battery.

  1. Connect the charging cord to the charger base and plug it into a suitable power source (120V AC or 12V DC).
  2. Insert the flashlight into the charger base. Ensure the charging contacts on the flashlight align with those in the charger.
  3. The charging indicator light on the charger will illuminate, typically red, to indicate charging is in progress.
  4. Allow approximately 10-12 hours for a full charge if the battery is completely depleted. The indicator light may change color (e.g., green) or turn off when charging is complete, depending on the charger model.

2.2 Battery Installation (if required)

The battery is typically pre-installed. If you need to replace or install the battery:

  1. Atsukite žibintuvėlio galinį dangtelį, pasukdami jį prieš laikrodžio rodyklę.
  2. Insert the NiMH battery with the positive (+) terminal facing towards the head of the flashlight.
  3. Užsukite galinį dangtelį atgal pagal laikrodžio rodyklę, kol jis bus tvirtai priveržtas.

3. Naudojimo instrukcijos

The Stinger LED HL 120/DC PB features multiple lighting modes controlled by a single push-button switch.

3.1 Įjungimas / išjungimas ir režimo pasirinkimas

  • Norėdami įjungti: Press and release the push-button switch. The flashlight will activate in the last used mode (High, Medium, or Low).
  • Norėdami perjungti režimus: With the flashlight on, press and release the switch repeatedly within 1.5 seconds to cycle through High, Medium, and Low brightness settings.
  • To activate Strobe: From any mode (on or off), press and hold the switch for approximately 2 seconds. Release to turn off strobe.
  • Norėdami išjungti: Press and release the switch when the flashlight has been in a single mode for more than 1.5 seconds.

3.2 Recharging the Flashlight

When the light output diminishes, it indicates the battery needs recharging. Follow the steps in Section 2.1 to recharge the flashlight.

4. Priežiūra

4.1 Valymas

  • Nuvalykite žibintuvėlio korpusą reklamaamp audinys. Nenaudokite abrazyvinių valiklių ar tirpiklių.
  • Clean the charging contacts periodically with a clean, dry cloth to ensure proper connection.

4.2 Baterijos priežiūra ir keitimas

  • For optimal battery life, avoid fully discharging the battery before recharging.
  • If the flashlight will not be used for an extended period, store it with a partial charge and recharge every few months.
  • Replace the NiMH battery when its run time significantly decreases. Use only genuine Streamlight replacement batteries.

4.3 Saugykla

Žibintuvėlį laikykite vėsioje, sausoje vietoje, apsaugotoje nuo tiesioginių saulės spindulių ir ekstremalių temperatūrų.

5. Problemų sprendimas

Dažniausiai pasitaikančias problemas ir jų sprendimus žr. toliau pateiktoje lentelėje.

ProblemaGalima priežastisSprendimas
Žibintuvėlis neįsijungia.Battery is depleted or improperly installed.Recharge the battery. Check battery orientation. Ensure tail cap is tightened.
Šviesa blanki arba mirga.Low battery charge. Loose connections.Recharge the battery. Ensure tail cap is tightened. Clean charging contacts.
Žibintuvėlis neįkraunamas.Charger not powered. Dirty charging contacts. Faulty battery or charger.Check power outlet. Clean charging contacts on flashlight and charger. Try a different power source. Contact customer support if issue persists.

6. Specifikacijos

FunkcijaDetalė
ModelisStinger LED HL 120/DC PB
Šviesos šaltinisLED
Baltas ryškumas800 liumenų (didelis ryškumas)
Maitinimo šaltinisMaitinamas baterijomis
Baterijos tipasNiMH (nikelio-metalo hidridas)
Baterijų skaičius1 (įskaičiuota)
MedžiagaAliuminis, Metalas
SpalvaMėlyna
Ypatingos savybėsRechargeable, Multiple lighting modes (High, Medium, Low, Strobe)
Atsparumo vandeniui lygisNeatsparus vandeniui
Prekės svoris3 svaro

7. Informacija apie garantiją

Streamlight products are known for their quality and durability. For specific warranty details, including coverage period and terms, please refer to the official Streamlight websvetainėje arba garantijos kortelėje, pridėtoje prie pirkinio. Išsaugokite pirkimo įrodymą, jei prireiktų pateikti garantijos pretenzijas.

8. Pagalba klientams

If you have any questions, require technical assistance, or need to report an issue that cannot be resolved using the troubleshooting guide, please contact Streamlight customer support. Visit the official Streamlight website for contact information, including phone numbers and email addresses.

© 2026 Streamlight. All rights reserved. Streamlight and Stinger are registered trademarks of Streamlight, Inc.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.