Command 5 lb Large Utility Hooks (Model 17003-MPES) Instruction Manual

Įvadas

The Command 5 lb Large Utility Hooks provide a damage-free solution for organizing and decorating your home, office, or dorm room. These hooks utilize advanced adhesive technology to hold strongly on various smooth surfaces and remove cleanly without leaving holes, marks, or sticky residue. Each large utility hook is designed to hold up to 5 pounds, offering versatile hanging options for a range of items.

Saugos informacija

• Nekabinkite virš lovų.
• Nenaudoti ant tapetų.
• Nenaudoti vertingiems daiktams kabinti.
• Ensure indoor temperature is between 50°F (10°C) and 105°F (40°C) for optimal adhesion.
• Wait seven days after painting before using Command Hooks to allow paint to cure.

Pakuotės turinys

Each package of Command 5 lb Large Utility Hooks includes:

• 14 x Large Utility Hooks
• 16 x Large Adhesive Strips

Sąranka ir diegimas

Follow these steps for proper installation to ensure maximum holding power and damage-free removal.

1. Paviršiaus paruošimas

Clean the desired surface with rubbing alcohol to remove any grime and dust. This allows the adhesive strips to bond effectively. Do not use household cleaners or water, as they can leave slippery residues that prevent proper adhesion.

2. Attaching Strips to Hooks

Separate the adhesive strips. Each strip has two sides. One side is marked for the wall, and the other for the hook.

Image: A hand demonstrates attaching the adhesive strip to the flat back of a Command Large Utility Hook. The strip is white with red 'Command' branding.

Press the adhesive strip firmly onto the back of the hook. Ensure the entire strip is pressed down for 30 seconds to create a strong bond.

3. Applying Hooks to the Wall

Remove the remaining liner from the adhesive strip, exposing the side that will attach to the wall.

Image: A hand presses a white Command Large Utility Hook firmly against a wall, demonstrating the application process.

Press the hook firmly against the prepared surface for 30 seconds. Apply pressure evenly across the entire hook to ensure full contact with the adhesive.

4. Curing Time

After applying the hook, wait 1 hour before hanging any items. This allows the adhesive to reach its maximum holding strength.

Naudojimo instrukcijos

Each Command Large Utility Hook can hold up to 5 pounds. They are suitable for a variety of items and surfaces.

Image: A visual guide showing compatible surfaces for Command hooks (painted walls, metal, painted concrete, laminate & finished wood, tile, smooth surfaces & glass) and incompatible surfaces (wallpaper, fabric, textured walls, brick, rough surfaces).

• Rekomenduojami naudojimo būdai: Hanging clipboards, brushes, dog leashes, kitchen utensils, home decor, accessories, and lightweight coats.
• Paviršiai: Painted walls, finished wood, painted concrete cinder blocks, laminate, glass, metal, and tiles.
• Surfaces to Avoid: Wallpaper, fabric, textured walls, brick, or rough surfaces.

Image: A kitchen wall with several Command hooks holding kitchen items and a bag of fruit, demonstrating practical, damage-free organization.

Priežiūra

Command hooks require minimal maintenance. To clean the hooks, simply wipe them with a damp cloth. Avoid using harsh chemicals or abrasive cleaners, as these may damage the plastic or affect the adhesive properties if they come into contact with the strips.

Pašalinimo procesas

To remove Command hooks without damaging your surfaces, follow these instructions carefully:

1. Lightly hold the top of the hook.
2. Slowly pull the adhesive strip straight down towards the floor. Do not pull the strip toward you or at an angle, as this may cause damage to the surface.
3. Continue pulling the strip until the hook releases from the wall. The strip will stretch up to several inches.

Image: A close-up of hands pulling the tab of a Command adhesive strip downwards, illustrating the proper technique for damage-free removal.

You can reuse your hook with new Command Refill Strips.

Trikčių šalinimas

Hook Not Sticking

• Ensure the surface was cleaned with rubbing alcohol only, not household cleaners or water.
• Verify the surface is smooth and not textured, wallpapered, or fabric.
• Confirm the indoor temperature is within the recommended range (50°F to 105°F).
• Ensure you waited 1 hour after application before hanging items.
• Check that the weight of the item does not exceed 5 pounds.

Strip Breaks During Removal

If the adhesive strip breaks during removal, it may be due to pulling it too quickly or at an angle. To remove the remaining strip:

• Gently slide a piece of dental floss or fishing line behind the hook/strip.
• Work the floss/line back and forth in a sawing motion to separate the adhesive from the wall.

Specifikacijos

Garantija ir palaikymas

3M pramoniniai ir profesiniai produktai yra skirti, paženklinti ir supakuoti pardavimui apmokytiems pramonės ir profesiniams klientams naudoti darbo vietoje. Jei ant atitinkamos produkto pakuotės ar literatūros nenurodyta kitaip, šie produktai nėra skirti, paženklinti ar supakuoti pardavimui ar naudojimui vartotojams (pvz., namams, asmeniniam naudojimui, pradinei ar vidurinei mokyklai, poilsiui / sportui ar kitais tikslais, neaprašytais atitinkamoje produkto pakuotėje ar literatūroje), ir turi būti parenkami bei naudojami laikantis taikomų sveikatos ir saugos taisyklių bei standartų (pvz., JAV OSHA, ANSI), taip pat visos produkto literatūros, naudotojo instrukcijų, įspėjimų ir kitų apribojimų, o naudotojas privalo imtis visų veiksmų, kurių reikalaujama pagal bet kokį atšaukimą, veiksmus vietoje ar kitą produkto naudojimo pranešimą. Netinkamas 3M pramoninių ir profesinių produktų naudojimas gali sukelti sužalojimą, ligą, mirtį ar turto sugadinimą. Jei reikia pagalbos renkantis ir naudojant produktą, kreipkitės į savo saugos specialistą, pramonės higienistą ar kitą šios srities ekspertą. Norėdami gauti daugiau informacijos apie produktą, apsilankykite www.3M.com.