CREWORKS 3L Ultrasonic Cleaner User Manual

Įvadas

This manual provides detailed instructions for the safe and efficient operation, maintenance, and troubleshooting of your CREWORKS 3L Ultrasonic Cleaner. Please read this manual thoroughly before initial use and retain it for future reference.

Saugos priemonės

• Neardykite įrenginio.
• Do not use flammable or corrosive liquids.
• Always use sufficient fluid to cover items.
• Unplug before filling & draining.
• Įsitikinkite, kad įrenginys pastatytas ant stabilaus, lygaus paviršiaus.
• Laikyti vaikams nepasiekiamoje vietoje.

Figure 1: CREWORKS 3L Ultrasonic Cleaner with its digital control panel and open lid, showcasing the stainless steel tank.

Kas yra dėžutėje

Išpakuodami patikrinkite, ar yra visi komponentai ir ar jie nepažeisti:

• 1 x Ultrasonic Cleaner Unit
• 1 x nerūdijančio plieno krepšelis
• 1 x maitinimo laidas
• 1 x Naudotojo vadovas (šis dokumentas)

Sąranka

1. Vieta: Place the ultrasonic cleaner on a firm, level, and dry surface, away from direct sunlight and heat sources. Ensure adequate ventilation around the unit.
2. Maitinimo jungtis: Connect the power cord to the unit and then to a grounded electrical outlet. Ensure the power switch on the back of the unit is in the OFF position before plugging in.
3. Bako užpildymas: Open the lid and fill the stainless steel tank with an appropriate cleaning solution. The liquid level should be between the MIN and MAX marks, ensuring items to be cleaned are fully submerged but not overflowing. Do not operate the unit without liquid in the tank.
4. Inserting Items: Place items to be cleaned into the stainless steel basket. Lower the basket gently into the tank. Avoid direct contact of items with the tank bottom to ensure optimal cavitation.

Figure 2: Close-up of the intuitive digital control panel, displaying temperature and timer settings for easy operation.

Naudojimo instrukcijos

1. Maitinimas: Flip the main power switch located on the back of the unit to the ON position. The digital display will illuminate.
2. Nustatyti temperatūrą: Press the "TEMP" button to adjust the desired cleaning solution temperature. Use the up/down arrows to set the temperature between 68°F and 176°F (20°C and 80°C). The unit will begin heating automatically.
3. Nustatyti laikmatį: Press the "TIME" button to adjust the desired cleaning duration. Use the up/down arrows to set the timer for up to 30 minutes.
4. Pradėkite valymą: Once temperature and time are set, the ultrasonic cleaning process will begin. The display will show the remaining time.
5. Veikimo metu: The unit will produce a slight humming sound and visible cavitation bubbles. This is normal. Avoid touching the tank or solution during operation.
6. Ciklo pabaiga: Įrenginys automatiškai išsijungs, kai laikmatis pasieks nulį.
7. Pašalinti elementus: Carefully lift the basket out of the tank. Rinse the cleaned items under clean water and dry them thoroughly.

Figure 3: Illustration of the powerful ultrasonic cavitation process, where 40 kHz frequency sound waves create microscopic bubbles that implode, effectively cleaning intricate surfaces.

Figure 4: Visual comparison demonstrating the effective cleaning results on various items, including eyeglasses, a razor, and a circuit board.

Priežiūra

• Bako ištuštinimas: After each use, especially if the solution is dirty, unplug the unit and drain the liquid using the built-in drain valve. Tilt the unit slightly towards the drain for complete emptying.
• Bako valymas: Rinse the stainless steel tank with clean water. Wipe the interior and exterior of the unit with a soft, damp Nenaudokite abrazyvinių valiklių ir nemerkite pagrindinio įrenginio į vandenį.
• Saugykla: Nenaudojamą įrenginį laikykite vėsioje, sausoje vietoje. Prieš sandėliavimą įsitikinkite, kad bakas yra visiškai sausas.
• Saugiklio keitimas: In case of power issues, check the fuse located near the power inlet. Replace with a fuse of the same rating if necessary. (Note: Refer to the product's electrical specifications for fuse type and rating).

Figure 5: Key design features contributing to durability and stable operation, including the robust stainless steel basin, noise-reducing cover, and non-skid rubber feet.

Trikčių šalinimas

Specifikacijos

Figure 6: Detailed dimensions of the ultrasonic cleaner unit and its removable cleaning basket.

Garantija ir palaikymas

CREWORKS stands behind the quality of its products. This ultrasonic cleaner comes with a 1-Year Promise. For any questions, technical assistance, or warranty claims, please contact our 24/7 Klientų aptarnavimas. Refer to the product packaging or the official CREWORKS websvetainė, kurioje rasite kontaktinius duomenis.

For more information and support, visit the official CREWORKS Store: CREWORKS Store on Amazon.