Įvadas
This manual provides essential information for the safe and efficient use of your Panasonic FY-30KW-W wall-mounted heat exchange ventilation fan. Please read these instructions thoroughly before installation and operation, and keep this manual for future reference.
Saugos informacija
Svarbios saugos priemonės:
- This product requires a pre-installed pipe for proper function. Refer to the construction manual for applicable pipe types. This unit cannot be installed on VP pipes.
- When operating the product, ensure the shutter lever is moved to the "open" position.
- If the outdoor temperature is -5°C or below, and the indoor temperature is 20°C with indoor relative humidity of 50% or more, condensation may form on the main unit's surface. Wipe any condensation with a cloth.
- During periods of low outdoor temperatures (below -10°C), or strong wind, rain, or snow (especially fog or powder snow), water or snow may enter with the supply air, causing dripping. In such cases, stop operation and close the shutter.
- Except for the conditions mentioned above, and during cleaning or inspection, do not stop operation to ensure continuous 24-hour ventilation.
- Multiple units cannot be operated with a single switch.
Sąranka ir diegimas
Proper installation is crucial for the performance and safety of the unit. It is recommended that installation be performed by a qualified professional.
Matmenys ir montavimas
Refer to the diagram below for external dimensions and mounting hole specifications. All measurements are in millimeters (mm).
Figure 1: External Dimension Diagram (Unit: mm)
Pagrindiniai matmenys:
- Pagrindinis blokas: Width 280 mm, Height 280 mm, Depth 332 mm.
- Mounting Holes (Main Unit): 12 holes, Ø5 mm.
- Mounting Holes (Duct Attachment): 4 elongated holes, Ø5 mm.
- Extension Duct: Length 160 mm, Diameter Ø144 mm.
Ensure adequate space for installation and maintenance access. The unit requires a pre-installed pipe; confirm compatibility with the construction manual. Do not install on VP pipes.
Naudojimo instrukcijos
The Panasonic FY-30KW-W fan is designed for continuous ventilation with heat exchange capabilities.
Pagrindinė operacija
- Maitinimas: Connect the unit to a single-phase 100V, 50/60 Hz power supply.
- Shutter Position: Before operating, ensure the shutter lever is moved to the "open" position.
- Ventiliatoriaus greičio pasirinkimas: The unit offers two fan speed settings: Stiprus ir Silpnas. Select the desired speed based on ventilation needs.
- Nepertraukiamas veikimas: For optimal indoor air quality, the unit is designed for 24-hour continuous ventilation. Avoid stopping operation unless necessary for maintenance or extreme weather conditions.
Specialios sąlygos
- In severe weather (outdoor temperatures below -10°C, strong wind, rain, snow, fog, or powder snow), stop the unit and close the shutter to prevent water/snow ingress.
Priežiūra
Regular maintenance ensures the longevity and efficiency of your ventilation fan.
Filtrų valymas ir keitimas
- The fresh air filter (for fine particles) should be cleaned approximately once a year.
- Replace the fresh air filter approximately once every two years.
- Pastaba: Filter replacement periods are guidelines. Depending on the usage environment, replacement may be required sooner.
Kondensacijos valdymas
- If condensation forms on the unit's surface under specific cold and humid conditions (outdoor -5°C or below, indoor 20°C and 50% humidity or more), wipe it immediately with a soft, dry cloth.
Trikčių šalinimas
This section addresses common issues you might encounter with your ventilation fan.
| Problema | Galima priežastis | Sprendimas |
|---|---|---|
| Įrenginys neveikia. | Power supply issue; Shutter closed. | Check power connection. Ensure shutter lever is in the "open" position. |
| Water/snow entering the room. | Extreme outdoor weather conditions (low temperature, strong wind, rain, snow, fog). | Stop operation and close the shutter immediately. Resume operation when weather improves. |
| Condensation on unit surface. | Cold outdoor temperature (-5°C or below) combined with high indoor humidity (20°C, 50% RH or more). | Wipe the surface with a dry cloth. Consider adjusting indoor humidity if possible. |
| Sumažėjęs oro srautas arba efektyvumas. | Clogged fresh air filter. | Clean or replace the fresh air filter as per maintenance guidelines. |
If problems persist after attempting these solutions, please contact Panasonic customer support or a qualified service technician.
Specifikacijos
Detailed technical specifications for the Panasonic FY-30KW-W heat exchange ventilation fan.
| Funkcija | Specifikacija |
|---|---|
| Modelio numeris | FY-30KW-W |
| Matmenys (P x G x A) | 280 mm x 332 mm x 280 mm |
| Svoris | 2.6 kg |
| Variklio tipas | 2-pole open capacitor induction motor |
| Nominalus maitinimo šaltinis | Single phase 100V, 50/60 Hz |
| Power Consumption (Strong/Weak) | 50Hz: 8.1W / 4.5W; 60Hz: 9.6W / 5.4W |
| Air Volume (Strong/Weak) | 50Hz: 30 m³/h / 18.5 m³/h; 60Hz: 30 m³/h / 18 m³/h |
| Effective Ventilation Volume (Strong/Weak) | 50Hz: 27.6 m³/h / 17.0 m³/h; 60Hz: 27.6 m³/h / 16.6 m³/h |
| Effective Ventilation Rate | 92 % |
| Noise Level (Strong/Weak) | 50Hz: 27 dB / 18 dB; 60Hz: 27 dB / 18 dB |
| Temperature Exchange Efficiency (Strong/Weak) | 67 % / 76 % |
| Heat Exchange Efficiency (Cooling, Strong/Weak) | 50 % / 58 % |
| Heat Exchange Efficiency (Heating, Strong/Weak) | 57 % / 68 % |
| Izoliacijos klasė | E |
| Medžiagos | Louver, main frame, ducts, fans, intake filter cover: PP resin; Supply shutter: ABS resin; Exhaust shutter: PE+PP resin |
Garantija ir palaikymas
Informacijos apie garantiją ieškokite prie gaminio pridėtoje garantijos kortelėje arba apsilankykite oficialioje „Panasonic“ svetainėje. website. For technical support, service, or inquiries, please contact Panasonic customer service.
Pastaba: The lifespan of components like filters can vary based on usage environment. The stated replacement periods are guidelines and not a guarantee of performance for the entire period.
